Fender American Performer Telecaster Neck- Maple

Maker:Fender

Model:American Performer Telecaster Neck

Condition:New

Description:

*Note: Stock photo- Grain pattern may vary. Please message us if you would like photos of the neck that would be shipped to you.*

Coast Sonic is an authorized Fender dealer.

Crafted in the same facility as our U.S.-made instruments, the American Performer Telecaster Neck works well with almost any playing style. Features include our comfortable Modern C neck profile with a satin urethane finish that give it a smooth, fast playing feel. A large, 70s era headstock adds mass and sustain and 22 jumbo frets make it easier to achieve wide, expressive bends.

This replacement neck is for a Fender or Squier by Fender guitar.

Because Fender genuine replacement necks have not been mounted to guitar bodies, nut slots must be cut by qualified personnel. Other installation processes may be required, such as fret work, fitting the neck to the neck pocket, and other instrument setup procedures. Your local FMIC Authorized Service Center can install genuine replacement necks; find authorized service center locations near you in the Support section of fender.com.

FEATURES

• Maple neck w/ walnut stripe
• Large 70s headstock
• Maple fingerboard with 9.5″ radius
• 22 jumbo frets
• Pre-slotted synthetic bone nut
• Six two-guide-pin tuning machine holes

• GENERAL

  • Neck ShapeModern “C”
  • Tuner Mounting ConfigDual Guide Pin

  MATERIALS

  • Fingerboard MaterialMaple
  • Neck MaterialMaple
  • Nut MaterialSynthetic Bone
  • Position InlaysBlack Dot
  • Neck FinishSatin Urethane
  • Truss Rod Nut1/8″ Hex Adjustment
  • Truss RodStandard

  MEASUREMENTS

  • Fingerboard Radius9.5″ (241 mm)
  • Scale Length25.5″ (64.77 cm)
  • Nut Width1.685″ (42.8 mm)
  • Number of Frets22
  • Fret SizeJumbo
  • Headstock Thickness.540 (13.71 mm)
  • Neck Thickness1st Fret – .820 (20.82 mm), 12th Fret – .870 (22.09 mm)
  • Peg Hole Diameter.404 (10.26 mm)